Upgrading your WebMasterONE Firmware



Please read the following instructions carefully before downloading your software.

If you have replaced your WebMasterONE core board, connect to the controller with your PC and look at the software version number on the System Summary page.

In order to have optimal performance, the software version should be s800v021, 3.003. If the software version is v021a but the firmware version after the comma is less than 3.003, follow the instructions below to download the firmware upgrade.

* Note that if you upgraded the software to v021a from a lower version, the firmware will upgrade to 3.003 at the same time.

  1. Click here to download the firmware upgrade. A dialog box will open, asking if you want to save or open the file. Choose "Save As". In XP and Vista, save it to your desktop (this makes it easy to find). In Windows 7 & 8, the file is saved in your "Downloads" folder.

  2. Plug in your USB flash drive. The drive window should open. If not, go to "My Computer", and open it (should be "Removable Media" drive). 

  3. Drag the Software Upgrade over to the USB drive. (Make sure that the Upgrade is the only file on the drive.)

  4. Unplug the USB flash drive from the computer.

Upload the firmware to your WebMasterONE.

  1. Plug the memory stick into the USB Host connections on the core interface board. The stick will only fit in one direction.

  2. Enter the Software Upgrade Menu. Press Next until the word START is highlighted, then press Enter.

  3. The Status section of the screen will indicate that the upgrade has started. Once it finishes (in a few minutes) the controller will reboot.

  4. Remove the memory stick. This may be used to upgrade as many controllers as you would like.

WebMasterONE Software Upgrade