EHE Series Metering Pump

The EHE is the workhorse of the E-Series metering pumps. EHE Series pumps have outputs up to 20 GPH (75 l/h) and pressure capabilities to 150 PSI (10 bar). Combining the EHE performance with a turndown ratio of 1800:1 yields one of the most versatile pumps in the water treatment industry today.

EHE SERIES PUMP
EH = Microprocessor control for all EHE models. Features manual speed control from 1 to 360 spm in 1 spm increments. External control from pulse signal with internal multiply and divide or from analog 4-20 mA signal.

CAPACITY/PRESSURE RATING
See chart below

CONTROL MODULE
E = For use on all EHE models, features external pulse capability.
(pulse divide, pulse multiply, analog)

VOLTAGE
1 = 115VAC, 50/60 Hz
2 = 230VAC, 50/60 Hz

LIQUID END
See chart on this page

OPTIONS
Blank = 1/2” O.D. tube connection and standard accessories.
(HV is 1/2” O.D. discharge x 1/2” I.D. suction)
V = Standard 1/2” tube connections with back pressure/anti-syphon valve added.
(Not available on FC models)
T = 3/4” NPT (male) pipe thread connection. (1/2” MNPT on HV pumps). No MAVV.
P = 3/4” NPT (male) connection (1/2” MNPT on HV pumps) with back pressure/anti-syphon valve. (No MAVV)

Note: NPT piping connection material of construction will be the same as the liquid end.All pumps include a manual air vent valve with the exception of FC/HV liquid ends and options P and T. All pumps include one foot valve, one injection valve, 20 feet of polyethylene tubing and one ceramic weight with the exception of HV models (tubing only) and options P and T.