Please read the following instructions carefully before downloading your software.

Upgrading the software on your WebMaster WIND is easy!  All you need is a 32 MB (or higher) USB flash memory stick.

1. Click on the applicable software upgrade link below. A dialog box will open, asking if you want to save or open the file. Choose "Save As". In XP and Vista, save it to your desktop (this makes it easy to find). In Windows 7 & 8, the file is saved in your "Downloads" folder.

1. Click on the applicable software upgrade link below. A dialog box will open, asking if you want to save or open the file. Choose "Save As". In XP and Vista, save it to your desktop (this makes it easy to find). In Windows 7 & 8, the file is saved in your "Downloads" folder.
   
   
2. Plug in your USB flash drive. The drive window should open. If not, go to "My Computer", and open it (should be "Removable Media" drive). 
   
   
3. Drag the Software Upgrade over to the USB drive. (Make sure that the Upgrade is the only file on the drive.)
   
   
4. Unplug the USB flash drive from the computer.

Upload the software to your WIND.

1. Plug the memory stick into the USB Host connections on the core interface board. The stick will only fit in one direction.
   
   
2. Enter the Software Upgrade Menu. Press Next until the word START is highlighted, then press Enter.
   
   
3. The Status section of the screen will indicate that the upgrade has started. Once it finishes (in a few minutes) the controller will reboot.
   
   
4. Remove the memory stick. This may be used to upgrade as many controllers as you would like.

• If your controller is software version s825v002, first upgrade to s825v006 using this link: s825v006.
  
  
• Then upgrade to s825v007 using the V007 file. If your controller is already at s825v006, just use the V007 file.
  
  
• If your controller is software version s825v007 thru 10, use the V022 file.
  
  
• If your controller is version s825v022, v022a, v023 or v024 use the V025 file.

Note: The software upgrade may create a new configuration file. If you have previously saved the configuration file, you should discard the old copy and export a new copy after performing the upgrade. Check all set points after performing an upgrade.